Bender for reinforcement bar 6-16mm PPM

The bending machine is designed for bending:

- in grooves of smooth and ribbed rods with a diameter of up to 12 - a radius of 35 mm

Bending element - a roller made of hardened steel.

- The core of the bending machine is hardened, and the bending angle is slightly rounded to increase strength.

- The bending machine is equipped with two additional stops for adjusting the length of the bent rod.

- The bending machine is equipped with an insert that reduces the gap in the core to 9 mm.

- A core with a groove 25 mm deep allows you to bend several small rods at the same time.

- The bending machine is equipped with an adjustable bumper that limits the movement of the handle, which makes it easier to bend rods at an angle of 90 degrees.

- Powder coated device The dimensions of the device are as follows:

- The length of the bending lever is 750 mm.

- The weight of the device is 6 kg.

- The base has dimensions of 200x200mm.